Setting steps to not execute by default

In the Configuration Manager, you can configure steps so they do not execute by default. This can be useful when you are designing a workflow and do not want the steps to execute their commands or other configurations as you are creating them.

This property is also available on the Properties tab on the Task Assistant window, but it must be re-set every time you start ArcMap. When it is set through the Configuration Manager, the property is applied as the default setting across ArcMap sessions until you change it again in the Configuration Manager dialog box.

1. Click Start > All Programs > Task Assistant Manager > Configuration Manager.

   The (Administrator) Configuration Manager dialog box appears.

   Note:

   If you do not have administrator privileges on the machine, the dialog box title is Configuration Manager, and you cannot change to Task Assistant designer mode.

2. Click the Settings tab.

   

3. Uncheck the Execute Step on Node Select check box to prevent a step from executing by default.

   Note:

   This property is also available on the Properties tab on the Task Assistant window.

4. Click Reread Current Settings to undo any changes and return the Configuration Manager to the current settings.
5. Click Reset to Default Values to reset the default settings.
6. Click Close.

Feedback on this topic?