Setting the save interval in the Production Properties dialog box

The geodatabase corporativa multiuser environment allows more than one user to save their changes to the product library geodatabase simultaneously. However, errors can occur when actions are performed at the same time. The save interval properties minimize these errors by automatically retrying the save operation after a set time interval. The most common operations that return these errors are creating and checking in products. When a save error occurs, the software waits and tries to create the product, or the check in, again. The attempt is repeated a number of times before returning an error and canceling the successful operation. You can configure the save interval and the number of tries in the Production Properties or Product Library Properties dialog boxes.

The following steps guide you through the process of changing save intervals in the Production Properties dialog box.

1. Start ArcMap.
2. On the main menu, click Customize > Production > Production Properties.

   The Production Properties dialog box appears.

3. If necessary, click Data Management.
4. Click the cell next to Number of Retries in the Enterprise Geodatabase Access section and type the number of attempts you would like the software to try before returning an error.

   The default is 60, but the value can be 0–5000.

5. Click the cell next Retry Save Interval (seconds) in the Enterprise Geodatabase Access section and type the time you would like the software to wait between each try.

   The default is 5 seconds, but the value can be 0–60.

6. Haga clic en Aceptar.