This document is archived and information here might be outdated. Recommended version. |
ArcObjects Help for .NET developers > ArcObjects namespaces > Geometry > ESRI.ArcGIS.Geometry > Interfaces > IE > IExtrude Interface > IExtrude.ExtrudeAlongLine Method (ArcObjects .NET 10.5 SDK) |
Extrude a geometry along a specified line, using the Zs on the two ends of the line to set Zs on the top and bottom.
[Visual Basic .NET] Public Function ExtrudeAlongLine ( _ ByVal extrusionLine As ILine, _ ByVal baseGeom As IGeometry _ ) As IGeometry
[C#] public IGeometry ExtrudeAlongLine ( ILine extrusionLine, IGeometry baseGeom );
[C++]
HRESULT ExtrudeAlongLine(
ILine* extrusionLine,
IGeometry* baseGeom,
IGeometry** extrudedGeom
);
[C++]
Parameters extrusionLine
extrusionLine is a parameter of type ILine baseGeom
baseGeom is a parameter of type IGeometry extrudedGeom [out, retval]
extrudedGeom is a parameter of type IGeometry
Creates a MultiPatch or Polyline from a base geometry by extruding the base geometry along an axis defined by the input Line. The base Z value of the geometry is uniformly set to the Z value of the Along Line's FromPoint and top Z value is uniformly set to the Z value of the Along Line's ToPoint. The top geometry is also shifted in the X and Y directions by an offset defined by the X and Y change of the Along Line between From and To Points. The resulting extrusion is always parallel to the XY-plane on both the base and top. The input line should be ZAware and ZSimple.
All non-linear segments are treated as linear segments when extrusion is performed. Only Polylines, Polygons, Envelopes, Points, and Multipoints are allowed as input geometries. Polylines, Polygons, and Envelopes will output MultiPatches while Points and Multipoints will output Polylines.
IExtrude Interface | IExtrude.ExtrudeBetween Method | IConstructMultiPatch.ConstructExtrudeAbsolute Method | IConstructMultiPatch.ConstructExtrudeBetween Method | IExtrude.ExtrudeAbsolute Method | IConstructMultiPatch.ConstructExtrudeRelative Method | IConstructMultiPatch.ConstructExtrudeFromTo Method | IConstructMultiPatch Interface | IConstructMultiPatch.ConstructExtrudeAlongLine Method | IConstructMultiPatch.ConstructExtrude Method | IExtrude.Extrude Method | IExtrude.ExtrudeFromTo Method | IExtrude.ExtrudeRelative Method | IExtrude.ExtrudeAlongLine Method | IExtrude Interface | IGlobeHeightProperties.ExtrusionExpressionString Property